Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
95
6 Installing the BlackDiamond 8810 Chassis
This chapter describes how to install a BlackDiamond 8810 switch chassis.
The BlackDiamond 8810 chassis fits in a standard 19-inch (48.26 cm) rack. You can install the switch
either flush against the back of the rack or in a mid-mount position to give you more access behind the
rack.
This chapter includes the following sections:
● Safety Information on page 95
● Unpacking the BlackDiamond 8810 Chassis on page 96
● Pre-Installation Requirements on page 99
● Attaching the BlackDiamond 8810 Mid-Mount Rack Brackets on page 100
● Rack Mounting the BlackDiamond 8810 Chassis on page 101
● Grounding the BlackDiamond 8810 Chassis on page 103
● Initial Management Access on page 104
Safety Information
Correct lifting procedures for the BlackDiamond 8810 chassis require two or more people.
Only trained service personnel should perform service to Extreme Networks switches and their
components. Trained service personnel have read all related installation manuals, have the technical
training and experience necessary to be aware of the hazards to which they are exposed in performing a
task, and are aware of measures to minimize the danger to themselves or other persons.
See Appendix A, “Safety Information” for additional safety information and Appendix B, “Technical Specifications”
for additional information regarding regulatory compliance certifications.
The BlackDiamond 8810 chassis should be empty before being lifted. This will also prevent damage to the system
components due to possible system chassis flex when lifting.
To Next Page
Loading...
