Extreme Networks BlackDiamond 8800 Series - Summit XGM2-2 Xf Option Card

Summit Option Cards
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
302
3 Loosen the two captive screws until they are completely free from the Summit option card.
4 Holding both captive screws, pull the XENPAK module out of the card.
WARNING!
XENPAK modules become very hot after prolonged use. Take care when removing a XENPAK from the switch. If
the module is too hot to touch, disengage the module and allow it to cool before removing it completely.
5 Place the XENPAK module immediately into an antistatic container to protect it from ESD damage
and dust.
6 If you are not installing another XENPAK module, cover the opening with a cover plate.
Summit XGM2-2xf Option Card
The Summit XGM2-2xf option card allows you to add up to two 10-gigabit XFP modules to the
following switches:
● Summit X450a-24t switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24tDC switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24x switch, running ExtremeXOS 11.6.1 (or later)
● Summit X450a-24xDC switch, running ExtremeXOS 11.6.1 (or later)
● Summit X450a-48t switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450e-24p switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450e-48p switch, running ExtremeXOS 11.6.1 (or later)
The Summit XGM2-2xf option card is compatible with the following 10-gigabit XFP modules:
● LR XFP module
● SR XFP module
Figure 210 shows the Summit XGM2-2xf option card.
Figure 210: Summit XGM2-2xf option card
SH_01 1