Extreme Networks BlackDiamond 8800 Series - Unpacking the Blackdiamond 8810 Chassis

Installing the BlackDiamond 8810 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
96
Unpacking the BlackDiamond 8810 Chassis
This section describes how to uncrate and unpack the BlackDiamond 8810 chassis. Re-crating and re-
packing instructions are also provided in the event that the BlackDiamond 8810 chassis needs to be
returned to Extreme Networks, Inc.
CAUTION
The BlackDiamond 8810 chassis weighs almost 80 pounds. Proper lifting and moving of the chassis requires two
people.
To uncrate and unpack the BlackDiamond 8810 chassis:
1 Verify that the Tilt Watch and Shock Watch indicators display a white state as shown in Figure 45.
Figure 45: Tilt watch and shock watch indicators
CAUTION
Do not proceed with uncrating and unpacking the chassis if either the Tilt Indicator or the Shock Indicator is
displaying a red warning state. Immediately contact Extreme Networks if a red condition occurs.
2 Open the flaps and remove the contents from the upper BlackDiamond 8810 shipping carton (see
Figure 46).
EX_084
Tilt watch
Tilt watch
in white state
Tilt watch
in red state
Shock watch
in white state
Shock watch
in red state
Shock watch