Extreme Networks BlackDiamond 8800 Series - 10 G2 X Module; XENPAK Ports

BlackDiamond 10808 Series Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
88
10G2X Module
Figure 43 shows the 10G2X module.
Figure 43: 10G2X module
The 10G2X module has two unpopulated XENPAK-based 10 Gigabit Ethernet ports.
If you have one MSM installed, all ports on the 10G2X module are switched through that MSM. If you
have two MSMs installed, the top port on the 10G2X module is switched through the MSM in slot A,
and the bottom port is switched through the MSM in slot B during normal operation.
The default configuration of the 10G2X module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
XENPAK Ports
The 10G2X module supports any of the following XENPAKs:
● SR XENPAK
● LR XENPAK
● ER XENPAK
● ZR XENPAK
● LX4 XENPAK
● LW XENPAK
NOTE
CX4 XENPAKs are also supported with Extreme Networks devices; contact your vendor to obtain these.
For more information about the supported XENPAK types and specifications, see “XENPAK Interfaces” on page 354.
Module status LEDs
10 Gbs ports
ASP035