Extreme Networks BlackDiamond 8800 Series - Chapter 9: Installing a Blackdiamond 10808 Chassis; Safety Information

Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
121
9 Installing a BlackDiamond 10808 Chassis
This chapter describes how to install the BlackDiamond 10808 chassis.
The BlackDiamond 10808 chassis fits into a standard 19-inch (48.26 cm) rack. You can install the switch
either flush against the back of the rack or in a mid-mount position to give you more access behind the
rack.
This chapter includes the following sections:
● Safety Information on page 121
● Required Tools and Resources on page 122
● Unpacking the Chassis and Preparing the Rack on page 122
● Installing the Chassis on page 128
● Grounding the BlackDiamond 10808 Chassis on page 134
● Initial Management Access on page 136
NOTE
Read the information in this chapter thoroughly before you attempt to install or remove the BlackDiamond 10808
switch.
Safety Information
CAUTION
Correct lifting procedures for the BlackDiamond 10808 chassis requires two or more people.
Only trained service personnel should perform service to Extreme Networks switches and their
components. Trained service personnel have read all related installation manuals, have the technical
training and experience necessary to be aware of the hazards to which they are exposed in performing a
task, and are aware of measures to minimize the danger to themselves or other persons.
NOTE
See Appendix A, “Safety Information” for additional safety information and Appendix B, “Technical Specifications”
for additional information regarding regulatory compliance certifications.
CAUTION
Before you lift a BlackDiamond 10808 chassis, make sure the chassis is empty to prevent unnecessary weight. This
will also prevent damage to the system components due to possible system chassis flex when lifting.