Extreme Networks BlackDiamond 8800 Series - Rack Mounting the Blackdiamond 8810 Chassis

Rack Mounting the BlackDiamond 8810 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
101
Rack Mounting the BlackDiamond 8810 Chassis
To install the BlackDiamond 8810 chassis in a rack:
1 Locate the 19-inch helper bracket that is shipped with the chassis.
2 Identify the rack location where the chassis will be installed.
3 Using four rack-mounting screws, attach the helper bracket to the system rack immediately below
the chassis location as shown in Figure 51.
You must provide the screws for attaching the helper bracket.
Figure 51: Attaching the helper bracket to the system rack
4 Lift the back of the empty chassis onto the helper bracket.
5 Slowly guide the chassis into the system rack until the mounting brackets are flush against the rack
uprights.
EX_086A