XFP Interfaces
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
353
To ensure that your XFP module is undamaged upon installation, you can correlate factory test data with your
installation site test data by consulting the average power reference values shown on the XFP module test data sheet
(Part No. 121080-00) enclosed with the module.
Removing an XFP Module
This section describes how to remove an XFP module. You can remove an XFP module from your
Extreme Networks switch or I/O module without powering off the system. The XFP module is shown
in Figure 239 on page 351.
To remove an XFP module:
1 Release the handle (bail latch) on the XFP module.
2 Carefully pull the XFP module out of the port.
3 Place the dust covers back into the XFP module connectors.
4 Place the XFP module immediately into an antistatic container to protect it from ESD damage and
dust.
To Next Page
Loading...
