Extreme Networks BlackDiamond 8800 Series - Page 352

Extreme Networks Optics
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
352
Figure 240: Accessing the XFP ports
4 Holding the module by its sides, partially insert the XFP module into one of the ports on the Summit
XGM2-2xf option card or the 10G4Xa module (see Figure 241).
5 Push the XFP handle (bail latch) upward until it clicks into place (see Figure 241).
6 Slide the XFP module as far back into the slot as possible, until you hear it click, indicating that it is
firmly attached (see Figure 241 and Figure 242).
Figure 241: Installing an XFP module
Figure 242: Installed XFP Module
NOTE
If you are installing only one XFP module, make sure that all unoccupied ports are covered with a rubber dust cover,
which is shipped with the option card (see Figure 242).
SH_023
Summit XGM2-2xf
Option Card
XFP Ports
SH_024
XFP Module
XFP Handle
SH_025
Installed
XFP Module
Cover Plate