Extreme Networks BlackDiamond 8800 Series - Er Xenpak

Extreme Networks Optics
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
356
Table 67 lists specifications for the LR XENPAK module.
NOTE
The launch power (measured using the average power method used by power meters) is measured at the factory. The
average launch power minimum value is provided as a reference, not a pass/fail criterion.
ER XENPAK
The ER XENPAK supports SMF and has SC connectors.
The ER XENPAK requires the software versions listed in Table 68.
Table 69 lists specifications for the ER XENPAK module.
Table 67: LR XENPAK module specifications
Parameter Minimum Maximum
Average launch power -7.3 dBm 0.5 dBm
Optical link budget 6.2 dB
Wavelength range 1260 nm 1355 nm
Distance range 2 m 10 km
Maximum receiver sensitivity in OMA -12.6 dBm
Table 68: ER XENPAK software requirements
Switch Model Required Software
BlackDiamond Switches
BlackDiamond 10808 ExtremeXOS 11.1.1 or later
BlackDiamond 8800 series ExtremeXOS 11.1.1 or later
BlackDiamond 12804 ExtremeXOS 11.4 or later
BlackDiamond 12802 ExtremeXOS 12.0 or later
Summit Switches
Summit X450 series ExtremeXOS 11.2.0 or later
Summit X450a series ExtremeXOS 11.2.0 or later
Summit X450e series ExtremeXOS 11.2.0 or later
Table 69: ER XENPAK module specifications
Parameter Minimum Maximum
Average launch power -4.7 dBm 4.0 dBm
Optical link budget 10.9 dB
Wavelength range 1530 nm 1565 nm
Distance range:
5 dBm attentuation
2 m 40 km
Maximum receiver sensitivity in OMA -14.1 dBm