Distinguishing a BlackDiamond 12800 Series MSM from an I/O Module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
77
The XM-2X module and XM-2XR module have two unpopulated XENPAK-based 10 Gigabit Ethernet
ports.
The default configuration of the XM-2X and XM-2XR I/O modules is as follows. All ports:
● Are added to the default VLAN as untagged.
● Inherit the properties of the default VLAN (for example, protocol type and VLANid).
XM-2X and XM-2XR LEDs
The XM-2X module and XM-2XR module have the following LEDs:
● Module status
● Module diagnostics
● Port status
Distinguishing a BlackDiamond 12800 Series MSM
from an I/O Module
A quick way to distinguish a BlackDiamond 12800 series MSM from a BlackDiamond 12800 series I/O
module is by the color of the release latch on each injector/ejector handle. Orange injector/ejector
release latches indicate that the module is a BlackDiamond 12800 series MSM, and green injector/ejector
release latches indicate that the module is a BlackDiamond 12800 series I/O module (see Figure 37).
Figure 37: Injector/ejector handle colors of the BlackDiamond 12800 series MSM and I/O modules
Module Slot Assignments
The specific slot locations for I/O modules and MSMs in the chassis are as follows:
● BlackDiamond 12804 switch
■ I/O modules in slots 1, 2, 5, and 6
■ MSMs in slots 3/A and 4/B
I/O module
release latches
are green
MSM
release latches
are orange
EX_158A
To Next Page
Loading...
