Extreme Networks BlackDiamond 8800 Series - Removing the Carton from the Chassis

Installing a BlackDiamond 10808 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
126
Removing the Carton from the Chassis
NOTE
You need at least 10 feet of overhead clearance to remove the shipping carton from the chassis.
To remove the carton from the chassis:
1 Remove the four v-boards from the corners of the crate, as shown in Figure 71.
Figure 71: V-boards in the chassis carton
2 Remove the four detachable plastic clip locks found near the bottom of the shipping carton, as
shown in Figure 72.
Two clip locks are located on each side of the carton.
EX_093A
V-boards