Extreme Networks BlackDiamond 8800 Series - Page 195

BlackDiamond 8806/12804 AC Power Cord Retainer Channel
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
195
3 Hold the AC power cord retainer channel in the position shown in Figure 123.
Figure 123: BlackDiamond 8806/12804 AC power cord retainer channel
4 Place the retainer channel against the switch as shown in Figure 124. Tighten the captive screw at
each end of the channel.
Figure 124: Securing the BlackDiamond 8806/12804 AC power cord retainer channel
5 Starting from the left, lay the first four power cords into the channel (see Figure 125).
6 Lay the last two power cords on top of the bottom four cords (see Figure 125).
EX_141
Captive screw
Captive screw
EX_139
Install and secure the channel bracket to
the switch by tightening both captive screws
Captive screw
Captive screw