Rack-Mounting the BlackDiamond 8806/12804 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
111
Figure 59: Mounting the 19-inch helper bracket onto the system rack
4 Lift the back of the empty BlackDiamond 8806/12804 chassis onto the 19-inch helper bracket.
5 Slowly guide the chassis into the system rack until the mounting brackets are flush against the rack
uprights.
6 Attach the chassis to the system rack using eight rack mounting screws. (Screws are not provided.)
Be sure that the screws are secure. Refer to Figure 60 for the screw locations.
Figure 60 shows a standard rack mount. For mid-mount installation, use the same mounting locations shown in
the figure, but insert the screws through the designated slot locations of the mid-mount brackets.
EX_086A
To Next Page
Loading...
