Grounding the BlackDiamond 10808 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
135
To ground the chassis:
1 Locate the grounding point on the back of the chassis (Figure 81).
Figure 81: Back of BlackDiamond 10808 chassis
2 Strip 0.5-inch (1.2-cm) of insulation from the stranded copper wire cable.
3 Insert the stripped wire into the cable lug.
Be sure that no copper is visible between the lug and the cable insulation.
4 Crimp the lug onto the cable according to the manufacturer’s specifications.
5 Insert the screws through the lug and into the grounding point on the back of the chassis.
6 Connect the other end of the wire to a known reliable earth ground point at your site.
EX_007A
Fan trays
Grounding
point
Power supply
controllers
To Next Page
Loading...
