Extreme Networks BlackDiamond 8800 Series - Page 162

Extreme Networks Power Supply Units for BlackDiamond Switches
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
162
Figure 94: Installing the Extreme Networks 325 W DC PSU
4 To secure the 325 W DC PSU in the power supply bay, align and tightening the two captive screws
on the PSU front panel. When you tighten the screws, work from left to right (see Figure 95).
Figure 95: Securing the Extreme Networks 325 W DC PSU
5 Verify that the DC input cord was connected to a permanent DC voltage source by a qualified,
licensed electrician.
6 Verify that the DC power is turned off at the source.
7 Plug the DC input cord into the DC input socket on the front of the 325 W DC PSU (see Figure 96).
Verify that the input connector latch locks onto the connector on the DC PSU.
The pins must align properly for the cable to connect. Do not force the cable into the socket.
D
C
O
U
T
D
C
I
N
Chassis
DC PSU
Torino DC PSU_01A
2
1
Torino DC PSU_02A