Extreme Networks BlackDiamond 8800 Series - Page 181

Installing a BlackDiamond 10808 Series Module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
181
Figure 110: Module orientation for insertion in a BlackDiamond 10808 system chassis
7 Slide the module into the slot until it makes contact with the backplane.
NOTE
Use the metal panel, not the circuit board, to guide the module into place.
As the module begins to seat in the chassis, the injector/ejector levers begin to close.
8 Close the injector/ejector levers, using both hands simultaneously to push the handles toward the
center of the module as shown in Figure 110.
9 Secure the module by tightening the two screws.
NOTE
Tighten the screws of each installed module before you insert additional modules. Otherwise, you might unseat
modules that you have not secured.
To install additional modules, repeat steps 3 through 9.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the chassis so that it is always available when you
need to handle ESD-sensitive components.
Captive
screws
Open
Open
Open
Injector/
ejector lever
Injector/
ejector lever
Open
Lock
Lock
Lock
Lock
EX_016
Module status LEDs
Module reset button
Console port
Management port
Compact flash