Extreme Networks BlackDiamond 8800 Series - Page 187

BlackDiamond Series Blank Front Panels
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
187
Figure 114: Captive screw on a BlackDiamond 8800/12800 blank front panel
3 Remove the blank front panel from the intended slot on the BlackDiamond switch (see Figure 115).
Figure 115: Blank front panel being removed from a BlackDiamond 8800 series or 12800 series
switch
4 Install an I/O module or MSM in the open slot as described in “Installing a BlackDiamond 8800 or
12800 Series Module” on page 175 or “Installing a BlackDiamond 10808 Series Module” on page 179.
NOTE
Leave the ESD-preventive wrist strap permanently connected to the switch, so that the strap is always available
when you need to handle ESD-sensitive components.
ASP019
ASP020