Extreme Networks BlackDiamond 8800 Series - Page 192

BlackDiamond AC Power Cord Retaining Brackets
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
192
Figure 118: Connecting an AC power cord to the BlackDiamond 8810 switch
4 Make sure that each AC power cord is firmly plugged into the power outlet as shown in Figure 119.
Figure 119: AC power cord plugged into the BlackDiamond 8810 switch power outlet
5 Align the BlackDiamond 8810 AC power cord retaining bracket over the AC power cord ends as
shown in Figure 120.
Figure 120: AC power cord retaining bracket correctly aligned
ASP009
ASP010
ASP012A
REMOVE TO INSTALL POWER CORDS