BlackDiamond Cable Management
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
198
Figure 126: Cable manager components
The cable manager is shipped assembled. You must remove the cover and the cable guides in order to
attach the cable manager base to the rack.
To install the cable manager:
1 At the top of the cover, lift the latches as you pull out on the corners to open the cover.
2 Rotate the cover outward and lift it off the base.
Removing the cover exposes the six screws holding the cable guides onto the mounting base (see
Figure 127).
EX_079
Cable manager cover
Cable manager base
Cable guides
Three screw attachments
each side
To Next Page
Loading...
