Repacking the BlackDiamond 8810 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
229
7 Attach all four restraining bolts to the four shipping brackets, securing the BlackDiamond 8810
chassis to the shipping pallet (see Figure 151).
Figure 151: Recrating the BlackDiamond 8810 chassis
8 Slide the BlackDiamond 8810 shipping carton down over the BlackDiamond 8810 chassis.
9 Insert the clip locks as shown in Figure 152.
a Place your thumb and index finger inside the clip lock touching the prongs.
b Squeeze the prongs inward applying equal pressure on each side.
c Push the prongs inward until the clip lock is secured to the carton.
d Repeat steps 8a through 8c to insert each of the remaining clip locks.
Figure 152: Clip locks located on BlackDiamond 8810 shipping carton
ASP016A
Install 4 bolts
securing chassis
to pallet
Slide carton
down over
chassis
EX_087B
Clip lock
Open
lock
Squeeze prongs
to unlock
To Next Page
Loading...
