Foundry Networks FESX User Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX
16 - 68 © Foundry Networks, Inc. December 2005
Displaying the IP Route Table
To display the IP route table, enter the following command at any CLI level:
Syntax: show ip route [<ip-addr> [<ip-mask>] [longer] [none-bgp]] | <num> | bgp | direct | ospf | rip | static
The <ip-addr> parameter displays the route to the specified IP address.
The <ip-mask> parameter lets you specify a network mask or, if you prefer CIDR format, the number of bits in the
network mask. If you use CIDR format, enter a forward slash immediately after the IP address, then enter the
number of mask bits (for example: 209.157.22.0/24 for 209.157.22.0 255.255.255.0).
The longer parameter applies only when you specify an IP address and mask. This option displays only the
routes for the specified IP address and mask. See the example below.
The none-bgp parameter displays only the routes that did not come from BGP4.
The <num> option display the route table entry whose row number corresponds to the number you specify. For
example, if you want to display the tenth row in the table, enter “10”.
The bgp option displays the BGP4 routes.
The direct option displays only the IP routes that are directly attached to the Layer 3 Switch.
The ospf option displays the OSPF routes.
The rip option displays the RIP routes.
The static option displays only the static IP routes.
The default routes are displayed first.
Here is an example of how to use the direct option. To display only the IP routes that go to devices directly
attached to the Layer 3 Switch:
Notice that the route displayed in this example has “D” in the Type field, indicating the route is to a directly
connected device.
FastIron SuperX Router> show ip route
Total number of IP routes: 514
Start index: 1 B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
1.1.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.2.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.3.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.4.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.5.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.6.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.7.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.8.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.9.0.0 255.255.0.0 99.1.1.2 1/1 2 R
1.10.0.0 255.255.0.0 99.1.1.2 1/1 2 S
FastIron SuperX Router(config)# show ip route direct
Start index: 1 B:BGP D:Connected R:RIP S:Static O:OSPF *:Candidate default
Destination NetMask Gateway Port Cost Type
209.157.22.0 255.255.255.0 0.0.0.0 4/11 1 D

Foundry Networks FESX Specifications

General

Brand	Foundry Networks
Model	FESX
Category	Switch
Language	English