Foundry Networks FESX User Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX
A - 4 © Foundry Networks, Inc. December 2005
Displaying the Syslog Configuration
To display the Syslog parameters currently in effect on a Foundry device, enter the following command from any
level of the CLI:
Syntax: show logging
The Syslog display shows the following configuration information, in the rows above the log entries themselves.
Table A.2: CLI Display of Syslog Buffer Configuration
This Field... Displays...
Syslog logging The state (enabled or disabled) of the Syslog buffer.
messages dropped The number of Syslog messages dropped due to user-configured
filters. By default, the software logs messages for all Syslog levels.
You can disable individual Syslog levels, in which case the software
filters out messages at those levels. See “Disabling Logging of a
Message Level” on page A-7. Each time the software filters out a
Syslog message, this counter is incremented.
flushes The number of times the Syslog buffer has been cleared by the clear
logging command or equivalent Web management interface option.
See “Clearing the Syslog Messages from the Local Buffer” on page A-
9.
overruns The number of times the dynamic log buffer has filled up and been
cleared to hold new entries. For example, if the buffer is set for 100
entries, the 101st entry causes an overrun. After that, the 201st entry
causes a second overrun.
level The message levels that are enabled. Each letter represents a
message type and is identified by the key (level code) below the value.
If you disable logging of a message level, the code for that level is not
listed.
messages logged The total number of messages that have been logged since the
software was loaded.
level code The message levels represented by the one-letter codes.
FESX424 Router> show logging
Syslog logging: enabled (0 messages dropped, 0 flushes, 0 overruns)
Buffer logging: level ACDMEINW, 3 messages logged
level code: A=alert C=critical D=debugging M=emergency E=error
I=informational N=notification W=warning
Static Log Buffer:
Dec 15 19:04:14:A:Fan 1, fan on right connector, failed
Dynamic Log Buffer (50 entries):
Dec 15 18:46:17:I:Interface ethernet 1/4, state up
Dec 15 18:45:21:I:Bridge topology change, vlan 4095, interface 4, changed
state to forwarding
Dec 15 18:45:15:I:Warm start

Foundry Networks FESX Specifications

General

Brand	Foundry Networks
Model	FESX
Category	Switch
Language	English