Foundry Configuration Guide for the FESX, FSX, and FWSX
D - 2 © Foundry Networks, Inc. December 2005
Table D.1 lists the software that is loaded into the device’s primary and secondary flash areas at the factory. All
the flash images are included on the CD-ROM shipped with the device.
Supported Features
Table D.2 lists the feature highlights in the FSX, FESX, and FWSX software.
Table D.1: Default Software Loads
Model Software Images
Primary Flash Secondary Flash
FESX424, FESX424HF
FESX448
FSX
Layer 2 Base Layer 3
FESX424-PREM
FESX448-PREM
FSX-PREM
Full Layer 3 Layer 2
FWSX424
FWSX448
Layer 2 Layer 2
Table D.2: List of Supported Features
Category, Description, and Configuration Notes
Supported on
FSX FESX FWSX
Management Features
Access Control Lists (ACLs) for controlling management access X X X
IronView Network Manager (optional standalone and HP OpenView GUI) X X X
Serial and Telnet access to industry-standard Command Line Interface
(CLI)
XXX
SNMP V1, V2, V3 X X X
Web-based GUI X X X
Security Features
802.1X port security
• Dynamic assignment for ACL, MAC filter, and VLAN
XXX
Access Control Lists (ACLs) for filtering transit traffic (applies to IP unicast
traffic only)
• Support for inbound ACLs only. These devices do not support
outbound ACLs.
XXX
Address locking X X X
To Next Page
Loading...
Need help?
General
