Configuring OSPF
December 2005 © Foundry Networks, Inc. 20 - 43
Displaying OSPF Route Information
To display OSPF route information for the router, enter the following command at any CLI level:
Syntax: show ip ospf routes [<ip-addr>]
The <ip-addr> parameter specifies a destination IP address. If you use this parameter, only the route entries for
that destination are shown.
Type The area type, which can be one of the following:
• Broadcast = 0x01
• NBMA = 0x02
• Point to Point = 0x03
• Virtual Link = 0x04
• Point to Multipoint = 0x05
Events OSPF Interface Event:
• Interface_Up = 0x00
• Wait_Timer = 0x01
• Backup_Seen = 0x02
• Neighbor_Change = 0x03
• Loop_Indication = 0x04
• Unloop_Indication = 0x05
• Interface_Down = 0x06
• Interface_Passive = 0x07
Adjacent Neighbor Count The number of adjacent neighbor routers.
Neighbor: The neighbor router’s ID.
Table 20.4: Output of the show ip ospf interface command
This field Displays
FastIron SuperX Router> show ip ospf routes
Index Destination Mask Path_Cost Type2_Cost Path_Type
1 212.95.7.0 255.255.255.0 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
173.35.1.220 212.95.7.251 Network Valid 00000000 7000
Paths Out_Port Next_Hop Type Arp_Index State
1 5/6 209.95.7.250 OSPF 8 84 00
Index Destination Mask Path_Cost Type2_Cost Path_Type
2 11.3.63.0 255.255.255.0 11 0 Inter
Adv_Router Link_State Dest_Type State Tag Flags
209.95.7.250 11.3.63.0 Network Valid 00000000 0000
Paths Out_Port Next_Hop Type Arp_Index State
1 5/6 209.95.7.250 OSPF 8 84 00
To Next Page
Loading...
