Foundry Configuration Guide for the FESX, FSX, and FWSX
21 - 38 © Foundry Networks, Inc. December 2005
FESX424 Router(config-bgp-router)# redistribute connected
FESX424 Router(config-bgp-router)# write memory
Syntax: [no] redistribute connected | ospf | rip | static
The connected parameter indicates that you are redistributing routes to directly attached devices into BGP.
The ospf parameter indicates that you are redistributing OSPF routes into BGP4.
NOTE: Entering redistribute ospf simply redistributes internal OSPF routes. If you want to redistribute
external OSPF routes also, you must use the redistribute ospf match external... command. See
“Redistributing OSPF External Routes” on page 21-39.
The rip parameter indicates that you are redistributing RIP routes into BGP4.
The static parameter indicates that you are redistributing static routes into BGP.
See the following sections for details on redistributing specific routes using the CLI:
• “Redistributing Connected Routes” on page 21-38
• “Redistributing RIP Routes” on page 21-38
• “Redistributing OSPF External Routes” on page 21-39
• “Redistributing Static Routes” on page 21-39
Redistributing Connected Routes
To configure BGP4 to redistribute directly connected routes, enter the following command:
FESX424 Router(config-bgp-router)# redistribute connected
Syntax: redistribute connected [metric <num>] [route-map <map-name>]
The connected parameter indicates that you are redistributing routes to directly attached devices into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295. The default
is 0.
The route-map <map-name> parameter specifies a route map to be consulted before adding the RIP route to the
BGP4 route table.
NOTE: The route map you specify must already be configured on the router. See “Defining Route Maps” on
page 21-48 for information about defining route maps.
Redistributing RIP Routes
To configure BGP4 to redistribute RIP routes and add a metric of 10 to the redistributed routes, enter the following
command:
FESX424 Router(config-bgp-router)# redistribute rip metric 10
Syntax: redistribute rip [metric <num>] [route-map <map-name>]
The rip parameter indicates that you are redistributing RIP routes into BGP4.
The metric <num> parameter changes the metric. You can specify a value from 0 – 4294967295. The default
is 0.
The route-map <map-name> parameter specifies a route map to be consulted before adding the RIP route to the
BGP4 route table.
NOTE: The route map you specify must already be configured on the router. See “Defining Route Maps” on
page 21-48 for information about defining route maps.
To Next Page
Loading...
Need help?
General
