Foundry Networks FESX User Manual

Foundry Configuration Guide for the FESX, FSX, and FWSX
22 - 20 © Foundry Networks, Inc. December 2005
Displaying Detailed Information
To display detailed VRRP or VRRPE information, enter the following command at any level of the CLI:
VRID The VRID configured on this interface. If multiple VRIDs are
configured on the interface, information for each VRID is listed in a
separate row.
CurPri The current VRRP or VRRPE priority of this Layer 3 Switch for the
VRID.
P Whether the backup preempt mode is enabled. If the backup preempt
mode is enabled, this field contains a “P”. If the mode is disabled, this
field is blank.
State This Layer 3 Switch’s VRRP or VRRPE state for the VRID. The state
can be one of the following:
• Init – The VRID is not enabled (activated). If the state remains
Init after you activate the VRID, make sure that the VRID is also
configured on the other routers and that the routers can
communicate with each other.
Note: If the state is Init and the mode is incomplete, make sure
you have specified the IP address for the VRID.
• Backup – This Layer 3 Switch is a Backup for the VRID.
• Master – This Layer 3 Switch is the Master for the VRID.
Master addr The IP address of the router interface that is currently the Master for
the VRID.
Backup addr The IP addresses of the router interfaces that are currently Backups
for the VRID.
VIP The virtual IP address that is being backed up by the VRID.
Table 22.3: CLI Display of VRRP or VRRPE Summary Information (Continued)
This Field... Displays...
FastIron SuperX Router(config)# show ip vrrp
Total number of VRRP routers defined: 1
Interface ethernet 1/6
auth-type no authentication
VRID 1
state master
administrative-status enabled
mode owner
priority 255
current priority 255
hello-interval 1 sec
advertise backup: disabled
track-port 2/4

Foundry Networks FESX Specifications

General

Brand	Foundry Networks
Model	FESX
Category	Switch
Language	English