Configuring IP
December 2005 © Foundry Networks, Inc. 16 - 67
The show ip cache command displays the following information.
Table 16.12: CLI Display of IP Forwarding Cache – Layer 3 Switch
This Field... Displays...
IP Address The IP address of the destination.
Next Hop The IP address of the next-hop router to the destination. This field
contains either an IP address or the value DIRECT. DIRECT means
the destination is either directly attached or the destination is an
address on this Foundry device. For example, the next hop for
loopback addresses and broadcast addresses is shown as DIRECT.
MAC The MAC address of the destination.
Note: If the entry is type U (indicating that the destination is this
Foundry device), the address consists of zeroes.
Type The type of host entry, which can be one or more of the following:
• D – Dynamic
• P – Permanent
• F – Forward
•U – Us
• C – Complex Filter
•W – Wait ARP
•I – ICMP Deny
• K – Drop
• R – Fragment
• S – Snap Encap
Port The port through which this device reaches the destination. For
destinations that are located on this device, the port number is shown
as “n/a”.
VLAN Indicates the VLAN(s) the listed port is in.
Pri The QoS priority of the port or VLAN.
To Next Page
Loading...
Need help?
General
