Foundry Networks Switch and Router User Manual

Using Packet Over SONET (POS) Modules
December 2000 6 - 21
5 minute output rate: 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 no buffer
Received 0 CRCs, 0 shorts, 0 giants, 0 alignments
0 packets output, 0 bytes, 0 underruns
Line protocol is UP
Member of 4 L2 VLANs, port is tagged, port state is FORWARDING
STP configured to ON
The lines shown in bold type in this example appear only if the port is enabled for Layer 2 switching.
Displaying POS Information
You can display the following POS module information:
• Software version – see “Displaying the Software Version Running on the Module” on page 6-21
• Displaying general module information – “Displaying General Module Information” on page 6-22
• Module status – see “Determining POS Module Status” on page 6-22
• Interface parameters – see “Displaying Interface Parameters” on page 6-23
• POS statistics – see “Displaying POS Statistics” on page 6-26
Displaying the Software Version Running on the Module
To display the software version running on the POS module, use ether of the following methods.
USING THE CLI
To display the software version running on the POS module, enter the following command at any CLI level:
BigIron> show version
SW: Version 07.1.05T1 Copyright (c) 1996-1999 Foundry Networks, Inc.
Compiled on Sep 29 2000 at 17:10:51 labeled as B2R07105
(1357024 bytes) from Primary b2r07105.car
HW: Chassis 4000 Router, SYSIF version 21
==========================================================================
SL 3: B8GMR Fiber Management Module, ACTIVE
2048 KB BRAM, SMC version 1, ICBM version 21
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA 8, version 0209
512 KB PRAM(512K+0K) and shared CAM entries for DMA 9, version 0209
512 KB PRAM(512K+0K) and 2048*8 CAM entries for DMA 10, version 0209
512 KB PRAM(512K+0K) and shared CAM entries for DMA 11, version 0209
==========================================================================
SL 4: B2P155 POS Module
2048 KB BRAM, SMC version 1, ICBM version 21
==========================================================================
240 MHz Power PC processor 603 (revision 7) 63 MHz bus
512 KB boot flash memory
8192 KB code flash memory
256 KB SRAM
128 MB DRAM
The system uptime is 45 seconds
The system : started=warm start reloaded=by "reload"
Syntax: show version
The command shows all the software versions running on the device. The POS information is shown in this
example in bold text.
USING THE WEB MANAGEMENT INTERFACE
You cannot display the POS module software versions using the Web management interface.

Foundry Networks Switch and Router Specifications

General

Brand	Foundry Networks
Model	Switch and Router
Category	Switch
Language	English