Foundry Switch and Router Installation and Configuration Guide
8 - 2 December 2000
Flash Images
The flash image (system software) that is running on a device determines the software features that are supported
by that device. Table 8.1 on page 8-2 lists the flash images that can be used on each Foundry device.
Notice that some devices can run either switch code or router code. For these devices, one type of code is always
installed at the factory by default. These devices can be reconfigured to run the other code by installing the
software and, in some cases, installing a firmware upgrade. Contact Foundry Networks or your reseller for details.
NOTE: Some features are supported only on specific products or require specific hardware configurations. See
the chapters describing those features or contact Foundry Networks or your reseller for information.
Table 8.1: Foundry Flash Software Images
Product Flash image Description
NetIron Internet Backbone router
BigIron
FastIron II
FastIron II Plus
TurboIron/8
BIRxxxxx.BIN
B2Rxxxxx.BIN (redundant
management module)
Router code
BIPxxxxx.BIN
B2Pxxxxx.BIN (redundant
management module)
IP-only router code
BISxxxxx.BIN
B2Sxxxxx.BIN (redundant
management module)
Switch code
BBRxxxxx.bin Switch code with basic Layer 3
support
P2Rxxxxx.BIN POS code
Note: Requires Management II or
higher
FastIron Workgroup FWSxxxxx.BIN Switch code
NBRxxxxx.bin Switch code with basic Layer 3
support
NetIron (Stackable device) N8Rxxxxx.BIN Router code for Chassis devices
with three LEDs per port
ServerIron 400
ServerIron 800
WSMxxxxx.bin (management
processor code)
WSPxxxxx.bin (web switching
CPU code)
ServerIron 400/800 code
ServerIronXL (8-, 16-, and 24-port
models)
ServerIronXL/TCS
SLBxxxxx.BIN Stackable ServerIron code
Note: For the ServerIronXL/TCS,
only the system-level features,
Layer 2 features, and TCS are
supported.
ServerIronXL/G BSIxxxxx.BIN Stackable ServerIron code
To Next Page
Loading...
Need help?
General
