Foundry Networks Switch and Router - Page 419

Using Access Control Lists (ACLs)
December 2000 13 - 31
The following command enables PBR by globally applying the route map to all interfaces.
BigIron(config)# ip policy route-map file-13
Alternatively, you can enable the PBR on specific interfaces, as shown in the following example. The commands
in this example configure IP addresses in the source sub-net identified in ACL 6, then apply route map file-13 to
the interface.
BigIron(config)# interface ethernet 3/11
BigIron(config-if-3/11)# ip address 192.168.1.204/32
BigIron(config-if-3/11)# ip policy route-map file-13