Foundry Switch and Router Installation and Configuration Guide
15 - 84 December 2000
• IP forwarding cache – see “Displaying the Forwarding Cache” on page 15-92.
• IP route table – see “Displaying the IP Route Table” on page 15-94.
• IP traffic statistics – see “Displaying IP Traffic Statistics” on page 15-97.
The sections below describe how to display this information.
In addition to the information described below, you can display the following IP information. This information is
described in other parts of this guide.
• RIP information – see “Displaying RIP Filters” on page 16-16.
• OSPF information – see “Displaying OSPF Information” on page 17-41.
• BGP4 information – see “Displaying BGP4 Information” on page 19-88.
• DVMRP information – see the “Show Commands” chapter in the Foundry Switch and Router Command Line
Interface Reference.
• PIM information – see the “Show Commands” chapter in the Foundry Switch and Router Command Line
Interface Reference.
• VRRP or VRRPE information – see “Displaying VRRP and VRRPE Information” on page 21-19.
• FSRP information – see the “Show Commands” chapter in the Foundry Switch and Router Command Line
Interface Reference.
Displaying Global IP Configuration Information
To display global IP configuration information for the router, use one of the following methods.
USING THE CLI
To display IP configuration information, enter the following command at any CLI level:
BigIron> show ip
Global Settings
ttl: 64, arp-age: 10, bootp-relay-max-hops: 4
router-id : 207.95.11.128
enabled : UDP-Broadcast-Forwarding IRDP Proxy-ARP RARP OSPF
disabled: BGP4 Load-Sharing RIP DVMRP FSRP VRRP
Static Routes
Index IP Address Subnet Mask Next Hop Router Metric Distance
1 0.0.0.0 0.0.0.0 209.157.23.2 1 1
Policies
Index Action Source Destination Protocol Port Operator
1 deny 209.157.22.34 209.157.22.26 tcp http =
64 permit any any
Syntax: show ip
NOTE: This command has additional options, which are explained in other sections in this guide, including the
sections below this one.
To Next Page
