Foundry Networks Switch and Router - Page 66

Foundry Switch and Router Installation and Configuration Guide
3 - 2 December 2000
Access to the Privileged EXEC
and CONFIG levels of the CLI
Not secured Establish a password for Telnet access to the
CLI
3-9
Establish passwords for management privilege
levels
3-10
Set up local user accounts 3-12
Configure TACACS/TACACS+ security 3-18
Configure RADIUS security 3-33
Telnet access Not secured Regulate Telnet access using ACLs 3-4
Allow Telnet access only from specific IP
addresses
3-5
Allow Telnet access only to clients connected
to a specific VLAN
3-6
Disable Telnet access 3-7
Establish a password for Telnet access 3-9
Establish passwords for privilege levels of the
CLI
3-10
Set up local user accounts 3-12
Configure TACACS/TACACS+ security 3-18
Configure RADIUS security 3-33
Secure Shell (SSH) access Not configured Configure SSH 4-1
Establish passwords for privilege levels of the
CLI
3-10
Set up local user accounts 3-12
Configure TACACS/TACACS+ security 3-18
Configure RADIUS security 3-33
Table 3.1: Ways to secure management access to Foundry devices (Continued)
Access method How the access
method is secured
by default
Ways to secure the access method See
page