Configuring BGP4
December 2000 19 - 89
Maximum Number of Paths
Supported for Load Sharing
The maximum number of route paths across which the device can
balance traffic to the same destination. The feature is enabled by
default but the default number of paths is 1. You can increase the
number from 2 – 8 paths. See “BGP4 Load Sharing”.
Number of Neighbors Configured The number of BGP4 neighbors configured on this Layer 3 Switch.
Number of Routes Installed The number of BGP4 routes in the router’s BGP4 route table.
To display the BGP4 route table, see “Displaying the BGP4 Route
Tab le” on page 19-107.
Number of Routes Advertising to All
Neighbors
The total of the RtSent and RtToSend columns for all neighbors.
Number of Attribute Entries Installed The number of BGP4 route-attribute entries in the router’s route-
attributes table. To display the route-attribute table, see “Displaying
BGP4 Route-Attribute Entries” on page 19-114.
Neighbor Address The IP addresses of this router’s BGP4 neighbors.
Table 19.4: BGP4 Summary Information (Continued)
This Field... Displays...
To Next Page
Loading...
