EasyManuals Logo

Foundry Networks Switch and Router User Manual

Default Icon
1070 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #837 background imageLoading...
Page #837 background image
Configuring VRRP and VRRPE
December 2000 21 - 11
Backup priority A numeric value that determines a Backup’s
preferability for becoming the Master for the VRID.
During negotiation, the router with the highest priority
becomes the Master.
• VRRP – The Owner has the highest priority
(255); other routers can have a priority from 3 –
254.
• VRRPE – All routers are Backups and have the
same priority by default.
If two or more Backups are tied with the highest
priority, the Backup interface with the highest IP
address becomes the Master for the VRID.
VRRP – 255 for the
Owner; 100 for each
Backup
VRRPE – 100 for all
Backups
21-15
Suppression of
RIP
advertisements
A router that is running RIP normally advertises
routes to a backed up VRID even when the router is
not currently the active router for the VRID.
Suppression of these advertisements helps ensure
that other routers do not receive invalid route paths
for the VRID.
Disabled 21-16
Hello interval The number of seconds between Hello messages
from the Master to the Backups for a given VRID.
The interval can from 1 – 84 seconds.
One second 21-4
21-16
Dead interval The number of seconds a Backup waits for a Hello
message from the Master for the VRID before
determining that the Master is no longer active.
If the Master does not send a Hello message before
the dead interval expires, the Backups negotiate
(compare priorities) to select a new Master for the
VRID.
Three times the Hello
Interval plus one-half
second
21-4
21-16
Backup Hello
interval
The number of seconds between Hello messages
from a Backup to the Master.
The message interval can be from 60 – 3600
seconds.
You must enable the Backup to send the messages.
The messages are disabled by default on Backups.
The current Master (whether the VRRP Owner or a
Backup) sends Hello messages by default.
Disabled
60 seconds when
enabled
21-4
21-17
Track port Another Layer 3 Switch port or virtual interface whose
link status is tracked by the VRID’s interface.
If the link for a tracked interface goes down, the
VRRP or VRRPE priority of the VRID interface is
changed, causing the devices to renegotiate for
Master.
None 21-5
21-17
Table 21.1: VRRP and VRRPE Parameters (Continued)
Parameter Description Default See page...

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Foundry Networks Switch and Router and is the answer not in the manual?

Foundry Networks Switch and Router Specifications

General IconGeneral
BrandFoundry Networks
ModelSwitch and Router
CategorySwitch
LanguageEnglish

Related product manuals