Route Health Injection
December 2000 26 - 9
Displaying Keepalive Information
To display the keepalive parameters in effect for the application ports on the servers, enter the following command
at any level of the CLI:
Syntax: show server keepalive-port
Name The name of the real server. This is the name you assigned to the
server when you configured it on the ServerIron.
IP The IP address of the real server.
If you configured a host range of VIPs on the server, the number
following the IP address (after the colon) is the number of hosts on the
server.
State The state of the real server. The state can be one of the states listed
by “Server State” at the top of the display.
Table 26.1: Real Server Information (Continued)
This Field... Displays...