135
EN
Pulsed/CMT cy-
cles
"Pulsed/CMT cycles" screen for CMT + P ADV charac-
teristics
N_CMT_Cycles
Number of CMT cycles
N_Puls_Cycles
Number of pulse cycles
End of welding
Guideline values Current guideline value
The current guideline value [A] is normally determined by trial and error or by performing
a test weld.
Guideline value for material
The guideline value for the material strength [mm] is normally determined by trial and error
or by performing a test weld
Voltage guideline value
The voltage guideline value [V] is normally determined by trial and error or by performing
a test weld. On the TS 4000/5000 and TPS 2700/4000/5000 power sources, the voltage
guideline value corresponds to the voltage on the contact tube.
k_I_p1_reg_gain
Effect of deviations [%] on the pulsing current
k_Vd_reg_gain
Effect of deviations [%] on the wirefeed speed
k_I_b_reg_gain
Effect of arc length correction [%] on the base current
I_p1_reg_delta_min
Lower control limit for the pulsing current Ip1 [A]
I_p1_reg_delta_max
Upper control limit for the pulsing current Ip1 [A]
t_burnback
Duration of the currentless wire withdraw [ms] after the welding current has been
switched off (v
D
= -6 m/min)
To Next Page
Loading...