Fronius RCU 5000i - Explanation of Q-Master Wire Feed Speed Values

97
EN
Explanation of Q-
Master wire feed
speed values
If the actual wire feed speed while job welding is greater than 15.5 m/min or less than 14.5
m/min for more than 0.3 sec, a reaction occurs in the form of a warning.
Wire feed speed command value
1)
E.g.: 15.0 m/min
- Value for the lower wirefeed speed limit - 0.5 m/min
= upper welding current limit value = 14.5 m/min
Wire feed speed command value
1)
E.g.: 15.0 m/min
+ Value for the upper wirefeed speed limit + 0.5 m/min
= upper wirefeed speed limit value = 15.5 m/min
Maximum duration of current deviation E.g.: 0.3 s
Reaction
2)
E.g.: Warning
1)
According to "Working parameters" screen
2)
According to "QMaster" screen