48
Setting working parameters
Setting working
parameters
MIG/MAG standard manual welding: "Working para-
meters" screen, wire feed speed selected
Call up "MIG/MAG standard manual
welding" menu item
Select "Working parameters" screen
by pressing the right arrow key (8)
– "Working parameters" screen ap-
pears
Select the corresponding working pa-
rameters using down (6) or up (7) keys
Use the adjusting dial (18) to alter the
parameter value
– The parameter value can only be
altered within the defined setting
range. The setting range is high-
lighted.
Trigger modes The following trigger modes can be set:
- 2-step
- 4-step
- Spot welding
1
2
3
4
To Next Page
Loading...