44
Setting addition-
al spot welding
parameters
If spot welding is selected as the trigger mode in the "Working parameters" screen, the cor-
responding screen is hung on the clothesline.
The following parameters can be set:
- Wire feed speed
- Arc length correction
- Spot welding time
"Working parameters" screen: spot welding trigger
mode
Call up "MIG/MAG synergic welding"
menu item
Select "Working parameters" screen
by pressing the right arrow key (8)
– "Working parameters" screen ap-
pears
Select the "trigger mode" parameter
using the down (6) or up (7) keys
Set spot welding using adjusting dial
(18)
Select "Spot welding" screen by pres-
sing the right arrow key (8)
– "Spot welding" screen appears
MIG/MAG synergic welding: "Spot welding" screen,
wirefeed speed selected
Select parameters using the down (6)
or up (7) keys
Change the value of the parameters
using the adjusting dial (18)
– The value of the parameters can
only be altered within the defined
setting range. The setting range is
highlighted.
1
2
3
4
5
6
7
To Next Page
Loading...