Fronius RCU 5000i - Removing a Memory Card; General

153
EN
Removing a memory card
General The memory card must be removed from the remote control unit (e.g. during weld-off
times) in order to evaluate the data.
The memory card can be removed at any time.
Removing a mem-
ory card
"Information - No data available" screen
In the corresponding "Data" screen,
press F5 "Remove SD card"
– The remote control unit checks
whether any welding data remains
in the cache memory.
– If there is no data in the cache me-
mory, the "Information - No data
available" screen appears.
– If data remains in the cache me-
mory, the "Save data" precautio-
nary query appears.
"Save data" precautionary query
To save the data, press F2 "Yes"
– "Information - Save complete"
screen appears
NOTE! When documenting to a memory card, always press F5 "Remove SD
card" before removing the card.
No data available.
Remove SD card.
1
Some documentation data
still remains in the buer.
Do you want to save it now?
2