49
EN
Switching to extra-large display
General The wirefeed speed, welding current and welding voltage parameters can be displayed in
extra-large format. The wire feed unit and push-pull unit motor current is also shown in the
"Extra-large display" screen as an actual value.
Switching to ex-
tra-large display
MIG/MAG standard manual welding: "Extra-large dis-
play" screen
Call up "MIG/MAG standard manual
welding" menu item
Select "Extra-large display" screen by
pressing the right arrow key (8)
– "Extra-large display" screen appe-
ars
– The values for wire feed speed
and welding voltage can be alte-
red in the "Extra-large display"
screen using the adjusting dial
(18).
– Welding current is a display value:
- during welding
... actual value
- following welding
... hold value
(1) Wire-feed unit motor current
(2) Push-pull unit motor current
(2)(1)
0.6 A
0.35 A
1
2
To Next Page
Loading...