Fronius RCU 5000i - Setting Welding Program and Filler Metal

52
Setting welding program and filler metal
General The welding program and filler metal can be set in the following menu items:
- MIG/MAG synergic welding
- MIG/MAG standard manual welding
- Optimising & managing jobs (only for saved MIG/MAG jobs)
Setting welding
program and filler
metal
"Select a filler metal" screen: Al99.5 selected
In the relevant "Data" screen, press F4
"Filler metal"
– The 1st screen in the wizard appe-
ars ("Select a filler metal")
Select required filler metal using the
adjusting dial (18)
Press F2 "Forward":
– The 2nd screen in the wizard ap-
pears ("Select a wire diameter")
– Only the wire diameters available
for the filler metal selected in the
1st screen are shown.
"Select a wire diameter" screen: 1.2 mm selected
Select corresponding wire diameter
using the adjusting dial (18)
Press F2 "Forward":
– The 3rd screen in the wizard ap-
pears ("Select a shielding gas")
– Only the gases available for the fil-
ler metal selected in the 1st
screen and wire diameter selected
in the 2nd screen are shown.
1
2
3
4
5