185
EN
Creating and editing keys
Assigning key
cards to profiles
(key setup)
Machine pre-sets - "Profiles / Keys" screen - "MIG/
MAG Welders" profile selected
Using the adjusting dial (18), select the
profile to which a key card is to be as-
signed
Press F1 "New key"
– The 1st screen in the wizard appe-
ars ("Enter name")
"Enter name" screen
Press F3 "Name key"
– "Name key" screen appears
"Name key" screen
Select corresponding characters using
the adjusting dial (18)
Press F4 ">" to enter the next charac-
ter
– Corrections can be carried out
using F3 "<" or F2 "< Delete"
Press F1 "Accept" when finished:
– The new name is accepted, "Enter
name" screen appears
1
2
3
4
5
6
To Next Page
Loading...