Fronius RCU 5000i - CC;CV Mode Operations; General Information; Setting Working Parameters

65
EN
CC/CV mode
General If the "CC/CV mode" software option is installed on the power source, the "CC/CV mode"
menu item appears in the main menu.
The CC/CV mode menu item allows the user to operate the power source with either con-
stant welding voltage or constant welding current.
Parameter changes in the "CC/CV mode" menu item can be made via a robot control or
the RCU 5000i remote control.
"CC/CV mode" is used in hot wire applications, for example.
Call up "CC/CV
mode"
Main menu: "CC/CV mode" menu item selected
Press the "Menu" button (1)
– Main menu appears
Select "CC/CV mode" menu item using
the adjusting dial (18)
Press OK (3)
– The last "Data" screen called up
appears
Setting working
parameters
CC/CV mode: "Working parameters" screen, current
command value selected
Call up "CC/CV mode"
Select "Working parameters" screen
by pressing the right arrow key (8)
– "Working parameters" screen ap-
pears.
Select the corresponding working pa-
rameters using down (6) or up (7) keys
Use the adjusting dial (18) to alter the
parameter value
– The parameter value can only be
altered within the defined setting
range. The setting range is high-
lighted.
1
2
3
1
2
3
4