90
Explanation of
correction bound-
aries
In job welding, the welding power can therefore be corrected between 14.6 m/min and 15.8
m/min.
In job welding, the arc length can therefore be corrected within the range of - 10.0% to +
30%.
The correction range for welding power is made up as follows:
set wirefeed speed E.g.: 15.0 m/min
+ value as % for upper power correction limit + 5.0 %
= upper limit for welding power = 15.8 m/min
set wirefeed speed E.g.: 15.0 m/min
- value as % for lower power correction limit - 3.0 %
= lower limit for welding power = 14.6 m/min
The correction range for arc length is made up as follows:
set arc length correction value E.g.: + 10.0 %
+ value as % for arc length correction bounda-
ries
+ 20.0 %
= upper limit for arc length = 30.0 %
set arc length correction value E.g.: + 10.0 %
- value as % for arc length correction bounda-
ries
- 20.0 %
= lower limit for arc length = -10.0 %
To Next Page
Loading...