203
EN
Aligning wirefeeder or push-pull unit
Aligning wire-
feeder (VR align-
ment)
Each time changes are made to the wirefeeder (e.g. replacing wire-guide liners), it must
be aligned.
Machine pre-sets: "MIG/MAG" screen
Call up the "Machine pre-sets" menu
item
Select "MIG/MAG" screen by pressing
the right arrow key (8)
– "MIG/MAG" screen appears
Press F3 "VR alignment"
– The 1st screen in the wizard appe-
ars ("Disengage the wire")
"Disengage the wire" screen
Follow the instructions given in the "Di-
sengage the wire" screen
– The "Disengage the wire" screen
relates to a push-pull system. As
long as the wire-feed unit to be
aligned is disengaged, begin the
VR alignment by pressing F2 "For-
ward".
Press F2 "Forward":
– The VR alignment is started, the
2nd in the wizard appears ("No-
load alignment")
"No-load alignment" screen
Once VR alignment is complete, the 3rd
screen in the wizard appears "Confirmati-
on".
1
2
3
4
5
To Next Page
Loading...