68
Switching to ex-
tra-large display
For a selected job, the wirefeed speed, welding current and welding voltage parameters
can be displayed in extra-large format.
Job welding: "Extra-large display" screen
Call up the "Job welding" menu item
Select "Extra-large display" screen by
pressing the right arrow key (8)
– "Extra-large display" screen appe-
ars
– The parameters "group no." and
"job no." can be selected using the
down (6) or up (7) keys, and alte-
red using the adjusting dial (18).
– The wirefeed speed can be adjus-
ted within the defined correction
boundaries for the job selected
using the adjusting dial (18).
– Welding current and welding vol-
tage are purely display values
(1) Wire-feed unit motor current
(2) Push-pull unit motor current
Changing the
welding process
during CMT Ad-
vanced welding
A 53.0A 6.0
(1) (2)
1
2
NOTE! Neither the welding process nor the currently selected characteristic can
be changed during CMT Advanced welding.
To change the welding process or characteristic:
- first, end the CMT Advanced process
- wait 300 - 600 ms
Another welding process or characteristic cannot be selected during this
time.
- Resume the welding process with another welding process or characteristic
To Next Page
Loading...