88
Retrieving and changing spot welding parameters
for a selected job
General The sequence of screens shown on the "clothesline" depends on the type of job selected.
The "Spot welding" screen only appears:
- if the trigger mode is set to S4-step for the job selected
- for MIG/MAG synergic jobs
Retrieving and
changing spot
welding parame-
ters for a job
Call up the "Optimizing & managing jobs" menu item
Whatever screen is showing, select "Group n°" parameter using the down (6) or up (7)
keys
Select desired group (0 - 99) using the adjusting dial (18)
Select "Job n°" parameter using the down (6) or up (7) keys
Select desired job (0 - 999) using the adjusting dial (18)
– If a job is selected from the next group, the group displayed also changes accord-
ingly.
Select "Spot welding" screen by pressing the right arrow key (8)
– "Spot welding" screen appears
Optimizing and managing jobs: "Spot welding" screen
Select the corresponding parameters
using down (6) or up (7) keys
Use the adjusting dial (18) to alter the
parameter value
– A parameter value can only be al-
tered within the defined setting
range. The setting range is high-
lighted.
1
2
3
4
5
6
7
8
To Next Page
Loading...