194
RCU 5000i - Unlock function
General An Unlock function has been added to the RCU 5000i remote control unit from software
version OFFICIAL RCU V1.14.12.
This Unlock function changes the "Locked" profile and enables access to the "Profile /
Keys" screen in the machine pre-sets in order, for example, to add an Administrator key or
modify the "Locked" profile.
Activating the
"Profile / Keys"
screen using the
Unlock function
Starting sequence
Disconnect the RCU 5000i from the
welding system or switch off the wel-
ding system
Insert memory card in the RCU 5000i
Connect the RCU 5000i to the welding
system or switch on the welding sys-
tem
– The starting sequence is display-
ed for about 2 seconds.
Press the Info key during the starting
sequence
– The information "The unlock file
for your RCU 5000i has been cre-
ated on the SD card." is displayed.
"Information - File has been created" screen
Press F3 "OK"
– The memory card now contains a
text file called "UREQUEST.TXT".
This file contains a number/letter
code that identifies the RCU
5000i.
Take the memory card out of the RCU
5000i and transfer "UREQUEST.TXT"
to a PC or laptop (e.g. using a standard
card reader)
E-mail "UREQUEST.TXT" to the following address:
– welding.techsupport@fronius.com
– Fronius will reply by sending you an e-mail containing the text file "UAC-
CESS.TXT". This file also contains a number/letter code.
Copy "UACCESS.TXT" to the memory card
1
2
3
4
The unlock le for your
RCU 5000i has been
created on the SD card.
5
6
IMPORTANT! The "UACCESS.TXT" file can only be used once to unlock the "Profile /
Keys" screen in the machine pre-sets.
7
8
To Next Page
Loading...