158
Ethernet setting
General Ethernet is a way of including a power source in a local network. If the Ethernet option
(UBST PCB with Ethernet connection) is installed on the power source, then the screen for
setting the Ethernet parameters will be available on the RCU 5000i. The screen is added
to the clothesline.
As an alternative to a PC or laptop, Ethernet settings for the respective power source can
be made from the RCU 5000i.
Software version V1.03.18 and higher of the RCU 5000i remote control unit supports the
UBST PCB.
More information about Ethernet can be found in the "Ethernet field bus" operating instruc-
tions.
Changing Ether-
net setting
Machine pre-sets: "Ethernet setting" screen
Call up the "Machine pre-sets" menu
item
Select "Ethernet setting" screen by
pressing the right arrow key (8)
– The "Ethernet setting" screen is
displayed
Press F3 "Change"
– The "Modify Ethernet setting"
screen is displayed
To reset the UBST setting to the factory set-
tings:
Press F5 "UBST factory"
Machine pre-sets: "Ethernet setting" screen
Select the desired Ethernet parameter
using the down (6) or up (7) keys
Select the desired parameter by pres-
sing F3 "<" or F4 ">"
Adjust the parameter using the adjus-
ting dial (18)
After setting the Ethernet parameter,
press F2 "Done"
– The "Ethernet settings" screen will
be displayed with the changed
Ethernet parameters.
NOTE! The setting of Ethernet parameters assumes a prior knowledge of net-
work technology.
1
2
3
1
IMPORTANT! The changed data will not be
transmitted to the UBST PCB until the wiz-
ard has finished.
4
5
6
7
To Next Page
Loading...